要篇内容介绍Executor的容错，容错方式有WAL、消息重放、其他
首先介绍WAL的方法，就是保存数据前，先把数据写日志。从ReceiverSupervisorImpl的pushAndReportBlock的方法开始看，代码如下
def pushAndReportBlock(
receivedBlock: ReceivedBlock,
metadataOption: Option[Any],
blockIdOption: Option[StreamBlockId]
) {
val blockId = blockIdOption.getOrElse(nextBlockId)
val time = System.currentTimeMillis
val blockStoreResult = receivedBlockHandler.storeBlock(blockId, receivedBlock)
logDebug(s"Pushed block $blockId in ${(System.currentTimeMillis - time)} ms")
val numRecords = blockStoreResult.numRecords
val blockInfo = ReceivedBlockInfo(streamId, numRecords, metadataOption, blockStoreResult)
trackerEndpoint.askWithRetry[Boolean](AddBlock(blockInfo))
logDebug(s"Reported block $blockId")
}调用receivedBlockHandler的storeBlock方法，receivedBlockHandler决定了采用哪种方式来存储数据，代码如下
private val receivedBlockHandler: ReceivedBlockHandler = { if (WriteAheadLogUtils.enableReceiverLog(env.conf)) { if (checkpointDirOption.isEmpty) { throw new SparkException( "Cannot enable receiver write-ahead log without checkpoint directory set. " + "Please use streamingContext.checkpoint() to set the checkpoint directory. " + "See documentation for more details.")
} new WriteAheadLogBasedBlockHandler(env.blockManager, receiver.streamId,
receiver.storageLevel, env.conf, hadoopConf, checkpointDirOption.get)
} else { new BlockManagerBasedBlockHandler(env.blockManager, receiver.storageLevel)
}
}如果开启WAL的方式，会将数据保存到checkpoint目录，如果checkpoint目录没有配置，就抛出异常。
先看WriteAheadLogBasedBlockHandler，开启WAL后，采用BlockManager存储数据时就不需要复本了，否则和WAL同时做容错就是重复性工作，降低了系统的性能。
再看BlockManagerBasedBlockHandler，就是将数据交给BlockManager存储，根据用户定义的存储级别来存储，系统一般默认存储级别为MEMORY_AND_DISK_SER_2，如果对数据安全性要求不高也可以不要复本。
消息重放就是一种非常高效的方式，采用kafka的Direct API接口读取数据时首先计算offset的位置，如果job异常，根据消费的offset位置重新指定kafka的offset，从失败的位置读取。kafka直接做为文件存储系统，就像hdfs一样，具体怎么使用以后的章节还会介绍。
作者：海纳百川_spark
链接：https://www.jianshu.com/p/bcca85d75043
随时随地看视频
